84
Start/stop from the operation panel (PU
operation mode)
Operation cannot be performed at the set frequency ... Why?
Did you carry out step 4 within 5s after step 3? (Did you press
within 5s after turning
?)
The frequency does not change by turning
... Why?
Check to see if the operation mode selected is External operation mode. (Press
to change to PU
operation mode.)
Operation does not change to the PU operation mode ... Why?
Check that "0" (initial value) is set in
Pr. 79 Operation mode selection
.
Check that the start command is not on.
Change acceleration time
Pr. 7 (Refer to page 61)
Change deceleration time
Pr. 8 (Refer to page 61)
For example, limit the motor speed to 60Hz maximum.
Set "60Hz" in
Pr. 1
.
(Refer to page 60)
REMARKS
· Press
to show the set frequency.
·
can also be used like a potentiometer to perform operation.
(Refer to page 85)
