Mitsubishi MOTORS Lancer 2017, Руководство пользователя

Страница: 86 / 385

Free-hand Advanced Security Transmitter (F.A.S.T.-key) (if so equipped)
Features and controls 5-21
5
 If the engine will not start because the bat-
tery is weak or discharged, refer to
“Jump-starting the engine” on page 8-2
for instructions.
 A longer warm up period will only con-
sume extra fuel. The engine is warmed up
enough for driving when the bar graph of
the engine coolant temperature display
starts to move. Refer to “Interrupt display
screen (With ignition switch in the “ON”
position)” on page 5-101.
Your vehicle is equipped with an electroni-
cally controlled fuel injection system. This is
a system that automatically controls fuel
injection. There is no need to depress the
accelerator pedal when starting the engine.
The starter motor should not be run for more
than 15 seconds at a time.
To prevent battery drain, wait a few seconds
between attempts to restart the engine.
1. Make sure all occupants are properly
seated with seat belts fastened.
2. Make sure the parking brake is applied.
3. Press and hold the brake pedal down
firmly with your right foot.
4. Press and hold the clutch pedal all the way
down (manual transaxle).
5. On vehicles with manual transaxle, place
the gearshift lever in the “N” (Neutral)
position.
On vehicles with continuously variable
transmission (CVT) make sure the selec-
tor lever is in the “P” (PARK) position.
6. While pushing the ignition switch from
“LOCK” (PUSH OFF) to “LOCK”
(PUSH ON), set the ignition switch to the
“ON” position and confirm that all warn-
ing lights and warning displays are oper-
ating properly.
7. Without pressing the accelerator pedal,
slowly turn the ignition switch to the
“START” position to start the engine.
Release the ignition switch when the
engine starts.
After several attempts, you may experience
that the engine still does not start.
WARNING
 Never run the engine in a closed or poorly
ventilated area any longer than is needed
to move your vehicle out of the area. Car-
bon monoxide gas, which is odorless and
extremely poisonous, could build up and
cause serious injury or death.
CAUTION
 Do not push-start the vehicle.
 Do not run the engine at high rpms or drive
at high speeds until the engine has had a
chance to warm up.
 Release the ignition switch as soon as the
engine starts. Otherwise, the starter motor
will be damaged.
Starting the engine
NOTE
 For models equipped with a manual trans-
axle, the starter will not operate unless the
clutch pedal is fully depressed (Clutch inter-
lock). This is a safety feature.
NOTE
 On vehicles with CVT, the starter will not
operate unless the selector lever is in the “P”
(PARK) or “N” (NEUTRAL) position.
For safety reasons, start the engine in the “P”
(PARK) position so that the wheels are
locked.
NOTE
 Minor noises may be heard on engine start-
up. These will disappear as the engine warms
up.
When the engine is hard to start
BK0237700US.book 21 ページ ２０１６年４月１５日 金曜日 午前１１時２８分