Mitsubishi MOTORS Lancer 2017, Руководство пользователя

Страница: 92 / 385

Free-hand Advanced Security Transmitter (F.A.S.T.-key) (if so equipped)
Features and controls 5-27
5
After several attempts, you may experience
that the engine still does not start.
1. Make sure that all electric devices, such
as lights, air conditioning blower and rear
window defogger, are turned off.
2. While depressing the brake pedal on vehi-
cles equipped with continuously variable
transmission (CVT) or the clutch pedal on
the vehicles equipped with manual trans-
axle, press the accelerator pedal halfway
and hold it there, then crank the engine.
Release the accelerator pedal, immedi-
ately after the engine starts.
3. If the engine still will not start, the engine
could be flooded with too much gasoline.
While depressing the brake pedal on vehi-
cles equipped with CVT or the clutch
pedal on the vehicles equipped with man-
ual transaxle, push the accelerator pedal
all the way down and hold it there, then
crank the engine for 5 to 6 seconds.
Return the ignition switch to the “LOCK”
position and release the accelerator pedal.
Wait a few seconds, and then crank the
engine again for 5 to 6 seconds while
depressing the brake pedal or the clutch
pedal, but do not push the accelerator
pedal. Release the ignition key if the
engine starts. If the engine fails to start,
repeat these procedures. If the engine still
will not start, contact your local Mitsubi-
shi Motors dealer or a repair facility of
your choice for assistance.
When the ambient temperature is -4 °F
(-20 °C) or lower, it may not be possible to
start from a standstill even with the selector
lever in the “D” (DRIVE) or “R”
(REVERSE) position.
This phenomenon occurs because the trans-
axle has not warmed up sufficiently; it does
not indicate a problem. If this occurs, place
the selector lever in the “P” (PARK) position
and let the engine idle for at least 10 minutes.
The transaxle will warm up, and you will be
able to drive normally.
Do not leave the vehicle during warm-up
operation.
N00529600101
The electronic immobilizer is designed to sig-
nificantly reduce the possibility of vehicle
theft. The purpose of the system is to immo-
bilize the vehicle if an invalid start is
attempted. A valid start attempt can only be
achieved (subject to certain conditions) using
a F.A.S.T.-Key “registered” to the immobi-
lizer system.
WARNING
 Make sure to remove the F.A.S.T.-key
from the emergency key after the engine is
started.
If not removed, the F.A.S.T.-key could fall
to the floor, which may interfere with
pedal operation.
Furthermore, the F.A.S.T.-key could pre-
vent the driver’s knee airbag from inflat-
ing normally or could be propelled to
cause serious injury if the airbag inflates.
NOTE
 When using the emergency key to start the
engine, first remove the key from the key
holder. If the emergency key is attached to a
key holder (key ring), it may become impos-
sible to insert the keyless operation key into
the emergency key, and it may prevent the
engine from being started.
When the engine is hard to start
Startability of continuously variable
transmission (CVT) vehicles at extremely
cold ambient temperature
Electronic immobilizer (Anti-
theft starting system)
BK0237700US.book 27 ページ ２０１６年４月１５日 金曜日 午前１１時２８分