Mitsubishi MOTORS Lancer 2004, Руководство по ремонту

Страница: 246 / 638

DOOR
BODY 42-28
DOOR WINDOW GLASS ADJUSTMENT
M1423001000327
Check that the door glass moves while contacting
the door glass channel when it is raised and lowered
fully. If not, adjust the door window according to the
following procedures.
1. Remove the door trim assembly (Refer to GROUP
52A, Door trim P.52A-15 ).
2. Remove the waterproof film (Refer to P.42-39 ).
3. Loosen the door glass mounting screw via the
adjusting hole with the door window glass fully
closed, then lower the window glass a little.
4. Fully close the door window glass again and
tighten the door glass mounting screw firmly via
the adjusting hole.
GLASS SLIDING MECHANISM CHECK
AND ADJUSTMENT
M1429000900091
If the window glass automatically starts moving
downwards at the wrong time while it is being raised,
carry out the following adjustment or replacement
procedures.
1. Remove the door trim assembly (Refer to GROUP
52A, Door trim P.52A-15 ).
2. Remove the waterproof film (Refer to P.42-39 ).
3. Remove the window regulator assembly from the
door window glass, and then raise and lower the
door window glass by hand to check the operation
force.
NOTE: Insert a cushion or similar object to
prevent damage to the glass if it should happen to
fall down.
4. If the door window glass does not move up and
down smoothly, check or repair the following
points.
•
Check the installation condition of the
runchannel.
•
Repair any twisting in the door sash.
•
Check the installation condition of the lower sash
or the centre sash.
NOTE: The lower sash cannot normally be
adjusted, but it may be possible to adjust the sash
span slightly within the range allowed by
manufacturing tolerances by pushing the lower
sash outwards while re-installing it.
5. If repair or adjustment is not possible, replace the
door assembly.
POWER WINDOW OPERATING CURRENT
CHECK
M1429001100184
1. Remove the power window fuse and connect an
ammeter as shown in the illustration.
2. When the power window switch is pressed to the
ìUPî position, a large amount of current flows at
the time the window starts to close and when it is
fully closed, so measure the operation current in
the interval between these two points.
Standard value (A): 5
±
1A (Power supply
voltage 14.5
±
0.5V, 25
°
C)
Y0238AU
Y0239AU
AC006112AB
<Front> <Rear>
Adjusting
hole
Adjusting
hole
AC003777
Runchannel
Door
sash
Lower
sash
AB
AC006115AB