Mitsubishi MOTORS Lancer 2004, Руководство по ремонту

Страница: 146 / 638

ON-VEHICLE SERVICE
REAR SUSPENSION 34-6
If camber is not within the standard value, adjust by
following procedures.
1. Disconnect the conjunction of the control link and
the trailing arm.
2. Carry out adjustment by turning the camber
adjusting bolt (lower arm assembly mounting bolt
which is located on the inner side of the body).
NOTE: .
•
LH: Clockwise viewed from the front
→
(+)
camber
•
RH: Clockwise viewed from the front
→
(-)
camber
•
The scale has gradations of approximately 14'.
CAUTION
To prevent bushings from breakage, the
connecting bolt should be temporarily tightened,
and then fully tightened to 90
±
10 N
⋅
m with the
vehicle on the earth in the unladen condition.
3. Tighten the control link to the trailing arm.
4. After adjusting the camber, the toe should be
adjusted.
TOE-IN
Standard value:
At the centre of tyre tread: 3
±
2 mm
Toe angle (per wheel): 0
°
08'
±
05'
If toe-in is not within the standard value, adjust by
following procedures.
CAUTION
To prevent bushings from breakage, the control
link mounting nut should be temporarily
tightened, and then fully tightened to 120
±
10
N
⋅
m with the vehicle on the earth in the unladen
condition.
Carry out adjustment by turning the toe adjusting bolt
(control link mounting bolt which is located on the
inner side of the body).
NOTE: .
•
LH: Clockwise viewed from the front
→
Toe-in
•
RH: Clockwise viewed from the front
→
Toe-out
•
Turning the toe adjusting bolt by one groove of
the scale, toe can be changed approximately 2.6
mm (single side toe angle equivalent to 16').
CONTROL LINK PILLOW BALL BUSHING
AXIAL PLAY CHECK <Sport>
M1341018500011
1. Raise the vehicle.
2. Move the control link up and down with your
hands to check for an excessive play in the axial
direction of the pillow ball bushing. If there is an
excessive play, replace the control link (Refer to
P.34-8 ).
AC006159 AC
Camber adjusting bolt
Lower arm
assembly
AC006160 AC
Connecting bolt
AC006145 AD
Control link
Toe adjusting bolt
Control link
<Control link front view> <Control link rear view>
Control link
mounting nut
AC304398 AB
Control link pillow ball bushing
Front of
vehicle