Mitsubishi MOTORS Lancer 2004, Руководство по ремонту

Страница: 206 / 638

FRONT AXLE HUB ASSEMBLY
FRONT AXLE 26-12
DISASSEMBLY SERVICE POINTS
<<A>> HUB REMOVAL
CAUTION
When the hub has been removed, always replace
the wheel bearing with a new part because wheel
bearing frictional surface will be damaged when
removing the hub.
Use the following special tools to pull out the hub
from the knuckle.
•
Knuckle arm bridge (MB991056 or MB991355)
•
Front hub remover and Installer (MB991017)
•
Spacer (MB991000)
<<B>> WHEEL BEARING REMOVAL
1. Crush the oil seal in two places so that the tabs of
the special tool will be caught on the wheel
bearing inner race (outside).
CAUTION
When removing the inner race (outside) from the
hub, be careful not to let the hub drop.
2. Remove the wheel bearing inner race (outside)
from the front hub by using special tool side
bearing puller (MB990810).
3. Install the inner race (outside) that was removed
from the hub to the wheel bearing, and then use
the following special tools to remove the wheel
bearing.
•
Installer bar (MB990938)
•
Installer adapter (MB990935)
•
Knuckle arm bridge (MB991056 or MB991355)
AC100130
Tighten the nut
with the bolt
secured
MB991056 or
MB991355
MB991017
MB991000
AB
AC102508 AC
Inner race
(outside)
Outer oil seal
AC102509
MB990810
Inner race
(outside)
AC
AC102510 AC
MB990938
MB990935
MB991056 or MB991355
Inner race
(outside)