Mitsubishi MOTORS Lancer 2004, Руководство по ремонту

Страница: 115 / 638

POWER STEERING GEAR BOX AND LINKAGE
POWER STEERING
37-31
<<E>> CIRCLIP REMOVAL
CAUTION
If the rack stopper is first turned anticlockwise,
the circlip will get caught in the slot in the
housing and the rack stopper will not turn.
1. Turn the rack stopper clockwise until the end of
the circlip comes out of the slot in the rack
housing.
2. Turn the rack stopper anticlockwise to remove the
circlip.
<<F>> RACK STOPPER/RACK
BUSHING/OIL SEAL/O-RING/RACK
ASSEMBLY REMOVAL
1. Pull out the rack slowly. Take out the rack stopper
and the rack bushing at the same time.
CAUTION
Do not damage the oil seal press fitting surface.
2. Partially bend the oil seal and remove it from the
rack bushing.
<<G>> LOWER BEARING REMOVAL
Use a brass bar or special tool brass bar
(MB990939) to remove the lower bearing from the
valve housing.
<<H>> NEEDLE BEARING REMOVAL
CAUTION
Do not open special tool excessively to prevent
damaging housing interior.
Use special tool needle bearing puller (MB991120) to
remove the needle bearing from the valve housing.
<<I>> OIL SEAL REMOVAL
CAUTION
Be careful not to damage the inner surface of the
rack cylinder of the gear housing.
Use a piece of pipe or similar tool to remove the oil
seal from the gear housing.
ACX01146 AB
Circlip
Rack stopper
ACX01147 AB
ACX01148AB
Rack bushing
ACX01149
MB990939
Lower bearing
AC
Valve housing
ACX01150
AB
Valve housing
MB991120
Needle
bearing
AC100259
Oil seal
Pipe or similar tool
Gear housing
AB