6
3. Operation
Battery installation/replacement
1. Remove the top cover, insert two LR6 AA bat-
teries, and then install the top cover.
2. Press the Reset button.
Ŷ
About the operation method, refer to the operation manual that comes with each remote controller.
3.1. Turning ON/OFF
[ON] [OFF]
Press the [ON/OFF] button.
The ON/OFF lamp will light up in
green, and the operation will start.
Press the [ON/OFF] button again.
The ON/OFF lamp will come off, and
the operation will stop.
Note:
Even if you press the ON/OFF button immediately after shutting down the operation is progress, the air conditioner will not start for about 3
minutes.
This is to prevent the internal components from being damaged.
■
Outdoor unit
Power
Earth
Indoor-Outdoor
Connection wire
Ref. Pipes
2. Parts Names
1
2
3
Press the Reset button with an
object that has a narrow end.
Top cover
1RWHV2QO\IRUZLUHOHVVUHPRWHFRQWUROOHU
Ŷ :KHQXVLQJWKHZLUHOHVVUHPRWHFRQWUROOHUSRLQWLWWRZDUGVWKHUHFHLYHURQWKHLQGRRUXQLW
Ŷ ,IWKHUHPRWHFRQWUROOHULVRSHUDWHGZLWKLQDSSUR[LPDWHO\PLQXWHVDIWHUSRZHULVVXSSOLHGWRWKH
indoor unit, the indoor unit may beep twice as the unit is performing the initial automatic check.
Ŷ 7KHLQGRRUXQLWEHHSVWRFRQ¿UPWKDWWKHVLJQDOWUDQVPLWWHGIURPWKHUHPRWHFRQWUROOHUKDVEHHQ
received. Signals can be received up to approximately 7 meters in a direct line from the indoor
XQLWLQDQDUHDWRWKHOHIWDQGULJKWRIRZHYHULOOXPLQDWLRQVXFKDVÀXRUHVFHQWOLJKWV
and strong light can affect the ability of the indoor unit to receive signals.
Ŷ ,IWKHRSHUDWLRQODPSQHDUWKHUHFHLYHURQWKHLQGRRUXQLWLVEOLQNLQJWKHXQLWQHHGVWREHLQVSHFWHG
Consult your dealer for service.
Ŷ +DQGOHWKHUHPRWHFRQWUROOHUFDUHIXOO\'RQRWGURSWKHUHPRWHFRQWUROOHURUVXEMHFWLWWRVWURQJ
shocks. In addition, do not get the remote controller wet or leave it in a location with high humidity.
Ŷ 7RDYRLGPLVSODFLQJWKHUHPRWHFRQWUROOHULQVWDOOWKHKROGHULQFOXGHGZLWKWKHUHPRWHFRQWUROOHURQ
a wall and be sure to always place the remote controller in the holder after use.
Ŷ ,IWKHLQGRRUXQLWEHHSVWLPHVZKHQ\RXDUHXVLQJWKHZLUHOHVVUHPRWHFRQWUROOHUVZLWFKWKHDXWR
mode setting to the AUTO (single set point) mode or AUTO (dual set point) mode.
For details, refer to the included Notice (A5 sheet) or the Installation Manual.
Two LR6 AA batteries
Insert the negative (–) end of each
EDWWHU\¿UVW,QVWDOOWKHEDWWHULHVLQ
the correct directions (+, –)!
BH79A366H01_en.indd 6
11/28/2017 1:31:15 PM
