56
6. NetCommand IR Control
To perform this procedure, you need:
The remote controls for both the TV and the
•
device you want to control.
The IR emitter cable supplied with the TV.
•
Note:
To set up an A/V receiver, see “Setting Up
NetCommand Control of an A/V Receiver,” page
60.
Connect and position the IR emitters for the
1.
devices you wish to control. See “IR Emitter Place-
ment” on the previous page.
Set the
2.
TV’s
remote control slide switch to the
TV
position and power on the TV if needed.
Open the NetCommand
3.
Learn
screen in one of two
ways:
If working from the
•
Auto Input Sensing
screen
for the device, highlight the
Learn
icon and
press
ENTER
to open the
Learn
screen for the
device.
If performing NetCommand setup at any time
•
after the device has been recognized through
Auto Input Sensing:
a.
Press
INPUT
to open the
Input Selection
menu.
b.
Highlight the desired input icon and press
ENTER
to switch to that input.
c.
Press
MENU
, highlight
Inputs
, and highlight
Learn
to open the
Inputs > Learn
screen
for the device.
The first function highlighted in the
4.
Learn
screen
is always
Power On
. Aim the
TV’s
remote control
at the TV and press
ENTER
to begin learning for that
function.
When the
5.
Power On
text starts flashing, aim the
device’s
remote control at the TV and press and
hold the
POWER
key until a check mark appears next
to
Power On
.
If the text stops flashing before the check mark
•
appears, repeat the previous step.
To remove the key from NetCommand control,
•
press the
CANCEL
key while the key name is
highlighted.
Press the
6.
keys on the
TV’s
remote control
to highlight other keys on the list. Repeat steps
4 and 5 for each additional function you wish to
control through NetCommand.
If the device’s remote control has keys that are not
7.
in the list, you can associate up to any four keys
with the
F1
through
F4
keys. Perform NetCommand
setup for the
F
keys the same way you did for the
named keys
.
For example, you can:
Assign your DVD player’s
•
CHAPTER SKIP FORWARD
and
CHAPTER SKIP BACK
keys to
F1
and
F2
.
“Learn” your A/V receiver’s DSP options for the
•
current device.
If the device has a separate
8.
POWER OFF
key, press
on the
TV’s
remote to highlight
Power Off
.
Repeat the earlier steps to “learn” the
POWER OFF
key.
If the device has no POWER OFF key, skip this step.
Press
9.
EXIT
to finish NetCommand “learning” for the
current device.
From the Auto Input Sensing screen, highlight the Learn
icon and press ENTER to open the NetCommand Learn
screen.
Inputs > Learn screen
Adding or Removing Device Keys
from NetCommand Control
Press
1.
INPUT
to open the
Input Selection
menu, high-
light the device’s icon and press
ENTER
.
Open the
2.
Inputs
menu and highlight the
Learn
icon.
When the
3.
Learn
screen displays:
To add keys: Continue as described earlier
•
under “Initial NetCommand Setup for Most
Devices” on this page.
To delete keys: Highlight the name of the key
•
you wish to delete and press
CANCEL
on the
TV‘s
remote control to clear the check mark.
Initial NetCommand Setup for Most Devices
