Mitsubishi Electric FR-V5NS, Инструкция по эксплуатации

Страница: 13 / 33

7
INSTALLATION
2.3 Installation and Removal
(1) Install the option unit to Slot 3.
(If you install it to Slot 1 or 2, E.OP1 (E.OP2) is displayed and operation is not performed.)
(2) Insert the option unit connector into the Slot 3 connector of the inverter securely. At this time, also insert the option
fixing holes securely.
Refer to the following diagram for the position of Slot 3. Push the option unit securely into the option fixing hook.
(3) Fix the two right and left places of the option unit to the inverter securely with the accessory mounting screws. If the
screw holes do not line-up, the connector may not have been inserted securely. Check for insecure insertion.
(4) To remove the option unit, remove the two left and
right screws, and then hold the option unit and pull
its bottom toward you as shown in the figure. (The
option unit is fixed by the hook of the inverter.)
CAUTION
You cannot use this option with any other communication options. Also, there are restrictions on some of the other
option functions. (Refer to page 24.)
Accessory screw (2 pcs.)
Option side connector (rear)
Slot 1
Inverter side connector
Slot 2
Slot 3
Option fixing hook
The option fixing hooks
are provided for Slots 1, 2, 3.
Inverter
(Without cover)