4. Setting up MELDASMAGIC64 System
4.3 Setting Up NC Card and Device Driver (ISA Card)
36
(9) A window for confirming the setup conditions of the hardware to be installed is displayed.
Make a note of the displayed resource type and its setting, and then click [Next>].
Fill in:
Resource type (The rotaty switch of card)
Setting
I/O port address (IOPADR)
IRQ (IRQ)
Memory range (DPADR)
* The setting may differ every time per installation.
!
CAUTION
Since the setting will be necessary for the future installation (4.3.1.2 Mounting NC Card), be
sure to make a note of it.
(10) Here, if the message of “The software for this device is now installed, but this device conficts with
one or more other devices…” is displayed, installation cannot be continued. Click [Cancel]. In this
case, refer to Problem 2 of chapter 6.3 “Troubleshooting,” and fix the hardware conflict before
installing the software again.
!
CAUTION
If hardware conflict occurs, be sure to click the [Cancel] button to abort installation. If you
click [Next >] to continue to install the software, the personal computer may not start up
normally.
Downloaded from
