Mitel TA7102, Руководство по установке

Страница: 27 / 53

TA7102 Hardware Installation
27
153/1531-ANF 901 14 B 2017-03-08
LED Patterns
– Default Behaviour
When no specific condition matches those described in Table 5, the LEDs behave individually according
to the following rules:
Table 6: Default LED Behaviour
LED Type Condition Behaviour
Power RestartInProgress Blinking, 1 Hz, 50% duty
RestartCompleted Steady ON
ETH Network traffic Blinking, variable rate
No network traffic Steady ON
In Use Lines Idle and Unlocked Steady OFF
Lines InUse and Unlocked Steady ON
Shutting Down Steady yellow
Locked Blinking yellow, 1 Hz, 50% duty
Ready All lines are enabled
(operational state). Steady ON
All lines are disabled
(operational state). Steady OFF
At least one line is enabled
and at least one line is
disabled (operational
state). Blink 0.25 Hz 75%
4.3 RESET/DEFAULT BUTTON
The RESET/DEFAULT button allows you to:

Cancel an action that was started.

Revert to known factory settings if the TA7102 refuses to work properly for any reason or the
connection to the network is lost.

Reconfigure a unit.
At Run-Time
The RESET/DEFAULT button can be used at run-time
– you can press the button while the TA7102
is running without powering the unit off. Table 7 describes the actions you can perform in this case.