misia XM SERIES, Инструкция по установке, эксплуатации и обслуживанию

Страница: 16 / 76

16
ELECTRIC WIRE ROPE HOIST
XM SERIES
ØM
e
h
(coupling thickness)
For any changes please contact the Technical
Department of MISIA.
3.4 PARTS SSEMBLY
Verify the technical data of the hoist comply
with the foreseen kind of operation, especially
the hook travel is not shorter than required and
that the operation capacity is equal or greater
than the loads to be lifted.
To assemble hoists Type 5C1 (suspended type)
always use the lock tab under the head of the
bolt and bend as shown. For the bolt diameter
see table A.
3.5 MOUNTING TROLLEY TYPE 3 AND 83
With the hoist on the pallet, lift it vertically with
a lift truck or platform.
The step to be performed is to elevate, not to
lift the hoist.
In case of hoists with monorail trolley Type 3
and Type 83, the trolleys are delivered with a
pre-set beam width. This value is indicated in
the order confirmation Check for compliance
and verify the space required on the catalogue.
Verify the feet base for hoist Type 5 as per the
catalogue drawing.
Verify the gauge of double rail trolleys Type 53
as per the catalogue drawing.
LT = Rail 3÷4 mm
D
Fig. 1
Table A
XM ØM e min
308 14 30+h
312-316 20 35+h
525 24 50+h
740-750 27 50+h
950-980 36 70+h
1100-1125 30 60*
* Not valid for suspended Type hoist (5C1)
SC
SC
3. INSTALLATION INSTRUCTIONS
Do not use derricks for this step, otherwise the
slings during lifting would hinder mounting on
the rail.
E
I