Miranda NV9606, Руководство пользователя

Страница: 45 / 90

NV9607 Control Panel • User’s Guide 35
5. Operation
Operating Concepts
It is not possible to take different sources to the destination on the same level. For instance, you
cannot take SD from two different sources. The outcome would be noise even if you could do it.
(That is because routers are not mixers.)
Hold
Hold mode (and hold buttons) apply in ‘Single Destination with Breakaway’ mode and ‘Limited
X-Y’ mode.
Breakaway
In single-destination mode with breakaway, a hold button retains breakaway levels after a take.
Simply press the hold button at any time before the take.
A hold button is a toggle. Press it once to put the panel in hold mode; press it again to remove hold
mode.
Limited X-Y
In limited X-Y mode, this button allows you to perform a gang (or “dub”) switch. In hold mode,
destination selections are cumulative, and not mutually exclusive.
Follow these steps to route a source to more than one destination:
1 Select the first destination to which you want to route the source. Use a ‘Destination Shift’ but-
ton if necessary to access the destination. The destination tallies bright amber and its name
appears in the destination display.
2 Press the hold button. If the panel is in hold mode, the hold button will be high-tally. (Press the
hold button again if it is not.)
3 Select the additional destinations you require. As you select each destination, its name appears
in the destination display. You can toggle these additional destinations on or off.
4 Select a source. Use a ‘Source Shift’ button if necessary to access the source. The take to the
multiple destinations is immediate.
5 As long as hold remains enabled, you can route other sources to the same group of destinations.
To clear hold mode:
1 Press the hold button. If it does not go low-tally, press it again.
2 Select any destination.
Source Preview
Your panel can have a ‘Source Preview’ button. This button turns “source preview mode” on or off.
Source preview mode can be used in any of the 4 operating modes.
When source preview mode is
off , pressing a source button completes a take.
When source preview mode is on , all buttons except source buttons, source-related buttons (such as
source shift), and the ‘Source Preview’ button are disabled and dark.
In source preview mode, pressing a source button does not complete a take. Instead, the source
name appears in the ‘Preview’ column of the display and a take button (if your panel has one) turns
red. It is necessary to press the take button to complete the take. After the take, the take button goes
dark once again.