6
Rev 1.0 • 21 May 10
2. Introduction
Panel Organization
Operators might need to scroll the display to see additional information. (‘Page Up’ and ‘Page
Down’ buttons are for scrolling the display.)
The display has 4 columns:
• Information (the left-most column, not labeled).
The first entry in this column is one of ‘X - Y’, ‘Single’, ‘1Dst/wBrk’, or ‘MultiDest” depend-
ing on the mode in which the panel is configured, unless the operator has entered menu mode,
or setup mode or has pressed an ‘Information’ button. See chapter 5 for those topics.
The bottom-most entry in this column is always the page number of the display.
In MD mode, there are no entries in this column other than “MultiDest” and the page number.
In the other modes, the second entry is always the word “Dest” as a title for the third entry
which identifies the current destination. In the preceding illustrations, the current destination is
VTR 1.
• Preview.
The preview column indicates what source will be routed to a destination if the operator presses
a ‘Take’ button.
S
This column is used only when the panel is in source preview mode. When the panel is not
in source preview mode, takes occur when the operator selects a source.
In MD mode, the preview column indicates the source(s) that will be routed to selected destina-
tion(s) in the ‘Level/Dest’ column. These are the
preset source(s)
. After the take, they disappear
from the preview column and re-appear in the status column, reflecting that the preset sources
have now become current sources.
In the other modes, the preview column represents the levels of a source or the levels of multi-
ple sources under breakaway. Here too, these are called the
preset source(s)
. After the take, they
disappear from the preview column and re-appear in the status column, reflecting that the preset
sources have now become current sources.
• Status.
The status column indicates what source was routed to the destination.
In MD mode, the status column represents the sources routed to each of the destinations in the
‘Level/Dest’ column. Again, these are the
current sources
.
In the other modes, the status column represents the levels of a source or the levels of multiple
sources under breakaway. These are called the
current source(s)
. The presence of ‘--------’ in
the status or preset columns means that that particular level is not defined for the destination.
Therefore, no source selection for that level is possible. The preceding illustrations show that
levels HD and ‘TimeCode’ are not defined for VTR 1.
• Level/Dest.
In MD mode, the ‘Level/Dest’ column presents all the MD destinations defined in the NV9607
configuration. (Actual destinations are defined in the NV9000 configuration.) Operators might
need to scroll to see or select a destination.
In the other modes, this column identifies the levels of the currently selected destination. That
destination is identified in the information column. In the illustration above, ‘VTR 1’ was
selected. Operators might need to scroll to see or select a level.
The ordering of levels (in all but multi-destination mode) is a configuration option.
Содержание NV9606
