MIRACALL TECHNOLOGY CO.,LTD
３６
PM position, then input “AM” or “PM “; If want to revise, press “ TRFR” key once, cursor shift to year
position ,then can input purpose year number and repeat the above procedure ,then confirm ,press “HOLD”
key once and exit from“00” item. If still want to program other item, hear “do” tone once, then input
purpose program item code and can program. Otherwise, press “ CLEAR” key twice or hook on and exit.
For example: setting system as 2004/01/01,Monday, 01:01 PM.
Press “ CHECK” three times in hook on status – >input “12345 press “TRFR” key once
–>input“01”+ press “TRFR” key once –>input“01”+ press “TRFR” key once –>input“1” + press “TRFR” key
once –>input“01” + press “TRFR” key once –>input“01” - >press “TRFR” key once –>input“1”+press
“HOLD” key once-press“ CLEAR” key twice and exit.
Operating at single line phone
Hook off, input “##787” and input system password “1234567”. Then input item code “00” after hear
dialing tone +input year press “*” key once and input month press “*” key once and
input date press “*” key once and input week day + press “*” key once and input hour number
press “*” key once and input minute press “*” key once and input “AM” or “PM”+ after finishing.
If still want to revise, then press“*” key once and cursor will shift to year position, back to input year
number and repeat the above procedure. After confirm, press “#” and exit from“00” item. If still want to
program other content, input purpose item code or hook on and exit.
For instance: setting system as 2004/01/01/, Monday, 01:01 PM.
Hook off and press “## 787 “-1234567-00-04*01*01*1*01*01*1-#- hook on to exit
* 2-5-02 Trunk Numbers Integrated
Function Introduction
If your company has several Trunk lines with different telephone numbers and these Trunk lines can
integrate one Trunk line, you can publish only one number by using this function. Therefore, calls for the
public number can be routed through all of the Trunk lines.
Default Setting
NIL
Notice
All the items sets are represent for the functions as the following:
* Trunk line port published set as the following at item No.01:
When Trunk line port set as “00101”, the numbers integrated is used circularly in turns. Every Trunk
line first dials first routes into system.
When Trunk line port set as “00121”, the end port is used to be superior to the other integrated
numbers. Every Trunk line firstly is chosen to use the end idle port when dialing in. The method is
often used.
*
The forth digit of item No.02 is used to adjust flash time between cancel instruction and set instruction
in slow selection method. The item is used according requirement and few used.
*
The second digit of item No.04 is set to “0” as slow selection and “1” as swift selection.
*
The forth digit of item No. 05 is set as delay time before release code when start trunk integrated
