Mira Element SLT, Инструкция по установке и эксплуатации

Страница: 17 / 28

17
2.5 mm
Hexagonal Key
Lever Insert
Hinge
Pin
Lever
Insert
Eco Flow
Device
Swap positions.
i.e. Refit Lever
Insert where Eco
Flow Device was
originally.
Cartridge Seal
6.
Remove the dome shroud, bearing and
chrome trim if fitted (Built in Models only).
7. Fit the multi tool onto the cartridge nut and
turn anticlockwise. Unscrew fully and pull the
cartridge from the mixer body.
8. Use the 2.5 mm hexagonal key or a suitable
sized screw driver to push the hinge pin from
left to right, releasing the lever insert (refer to
illustration).
9. Repeat the procedure to remove the eco flow
device.
10. Rotate the cartridge 180°.
11. Refit the eco flow device in the location that
the lever insert was originally removed from,
pushing the hinge pin in from right to left.
13.
Make sure that the two cartridge inlet seals
are fitted and carefully push the cartridge into
the body, aligning the cartridge lugs into the
body slots.
Note! Check that the cartridge lug stamped
‘H’ is aligned with the hot inlet supply.
Important! Take care when fitting the cartridge
as damage to the cartridge inlet seals may
result in dripping from the shower head.
14. Tighten the nut by turning the multi tool
clockwise.
Note!
Please ensure it is tightened fully.
15.
Reassemble in reverse order.
16. Before using the Shower, refer to section:
‘Commissioning’ .
Lever
Insert.
Lever Insert
must re-engage
correctly.
12.
Repeat the procedure to refit the lever insert
making sure that it re-engages correctly with
the cartridge.
Note! When the pin is fitted correctly it will be
flush with the Lever Insert.