Mira Element SLT, Инструкция по установке и эксплуатации

Страница: 13 / 28

13
Solid Wall or Stud Partition Fixing
using Securing Brackets
1. Refer to section: ‘Solid Wall or Stud Partition
Fixing using Rear Mountings’ and follow
build instructions 1 to 4.
2. Remove the plasterboard and/or brick work to
a minimum depth of 55 mm.
3. Fit the securing brackets to the mixer with the
bracket securing screws.
Important! Make sure that the correct holes
are used, otherwise the backplate cannot be
fitted.
Note! The securing brackets can be rotated
for suitable fixing points.
55 mm Min
20 mm Max
Finished Wall
4 mm Min
Finished Wall
Finished Wall
Surface
Securing
Bracket
Rotate for Suitable Fixing Point
Backplate Securing Hole
Backplate Securing Hole
Countersunk Fixing Hole
Note! Securing Brackets shown
in preferred position to allow the
Compression Nuts to be tightened.
4. Make sure that the mixer is level and mark the
positions for the countersunk fixing holes on
the wall.
5. For solid walls drill two Ø6 mm holes for the
wall plugs. Caution! Do not drill into pipes in
the wall.
6. Fit the hot and cold supply pipework ( Hot -
Left, Cold - Right ).
7. Caution! It is essential at this point
that the supply pipework is thoroughly
flushed through before connection to the
mixer.
Failure to do so may result in product
malfunction and will not be covered under the
guarantee.
8. Insert the wall plugs and attach the mixer to
the wall with the screws provided.
Note! For stud partition installations alternative
fixings may be required (not supplied).
9. Make sure that the olives are fitted, connect
the hot and cold supply pipes and tighten the
compression nuts.
10. Connect the outlet pipework and install the
RAC assembly or BIR assembly,
before
continuing with the installation of the mixing
valve.
RAC assembly , go to section: ‘I nstallation,
RAC Assembly’ .
BIR assembly , refer to your shower fittings
installation and user guide then continue with
build instruction 11.
11. Turn on the water supplies and check for
leaks.
12. Remove the two shroud screws and refit the
building-in shroud to the mixer.
Screws
Outlet Pipe to Fittings
Hot Supply
Cold Supply