Mira Element SLT, Инструкция по установке и эксплуатации

Страница: 11 / 28

11
Screws
Outlet Pipe to Fittings
Hot Supply
Cold Supply
Shroud Screw
F13125 Finished Wall
Min
Max
Minimum finished
wall surface
Maximum finished
wall surface
13.
Turn on the water supplies and check for
leaks.
14. Remove the two shroud screws and refit the
building-in shroud to the mixer.
15. Using the ‘Finished Wall Indicator’ on the
building-in shroud as a guide, finish the wall,
e.g. tiles.
Caution! Make sure that the finished wall
is within the maximum and minimum limits
and to an even depth (no greater than 2 mm
variation) or the control components will not fit
correctly.
16. Remove the building-in shroud and secure
the chrome trim to the mixer using two of the
bracket securing screws.
17. Fit the concealing plate and control assembly,
refer to section: ‘Control Assembly’ .
6.
Make sure that the mixer is level and central
in the hole and square to the finished wall
surface (or the control components will not fit
correctly), then mark the positions of the fixing
screw holes on the wall.
7. For solid walls drill two Ø6 mm holes for the
wall plugs.
8. Fit the hot and cold supply pipes ( Hot - Left,
Cold - Right ).
9. Caution! It is essential at this point
that the supply pipework is thoroughly
flushed through before connection to the
mixer. Failure to do so may result in product
malfunction and will not be covered under the
guarantee.
10. Insert the wall plugs and attach the mixer to
the wall with the screws provided.
Note! For stud partition installations alternative
fixings may be required (not supplied) to fix the
mixer to the rear face of the wall cavity or to a
timber noggin.
11. Make sure that the olives are fitted and connect
the hot and cold supply pipes, then tighten the
compression nuts.
12. Connect the outlet pipework and install the
RAC assembly or BIR assembly, before
continuing with the installation of the mixing
valve.
RAC assembly , go to section: ‘I nstallation,
RAC Assembly’ .
BIR assembly , refer to your shower fittings
installation and user guide then continue with
instruction 13.