minnkotamotors.com | 19
©2018 Johnson Outdoors Marine Electronics, Inc.
a. Take the Hand Controller (Item #C) and determine
a mounting location by reviewing the mounting
considerations at the beginning of this section. Take
the Loop side of the Fabric Pad supplied (Item #14)
and remove the adhesive backing. Stick it to the
back of the Hand Controller.
b. Make sure that the Mounting Location is clean and
dry. Take the Hook side of the Fabric Pad (Item #16)
and stick it to the mounting location. Press the Hook
and Loop Fabric Pad together.
c. Make sure the Hand Controller is in the “OFF”
position.
d. Route the cable from the Hand Controller through a
side wall or along the edge of the floor of the boat to
the battery area where the Control Module is located.
e. Plug in the Hand Controller cable to the matching
cable on the back side of the Control Module. Make
sure this cable is threaded together snug and secure.
f. Route the wires in a way that they will not be a
tripping hazard. Secure any excess wires by tucking
them away or securing them with a tie.
1
2
ITEM(S) NEEDED
#14 x 1
#16 x 1
#C x 1
Installing the Hand Controller and Connecting it to the Control Module
INSTALLING THE HAND CONTROLLER AND CONNECTING IT TO
THE CONTROL MODULE
The Hand Controller comes equipped with approximately 18 feet
of cable and is designed to be installed at or near the driver’s seat.
Hook and Loop with self adhesive is supplied to mount the Hand
Controller to any smooth surface. This allows you to remove the
Hand Controller and operate it from anywhere in the boat. The
controller, for example, can be mounted on or near the dash
board, placed by the throttle control for the main engine or on the
side of the driver’s seat. Be sure the surface where you are going to mount the controller is clean and dry.
Mounting
Location
Loop Side
of Fabric
Pad
Hand
Controller
Hand
Controller
Hook side
of Fabric
Pad
NOTICE:
The Cable for the Hand Controller is threaded
with a 5 point plug.
Hand
Controller
Threaded Plug
from Hand
Controller
Plug from
Control Box
"OFF"
Position
WARNING
Route the cables from the Control Module to the Hand
Controller in a way that they do not cause a tripping hazard.
WARNING
Arcing (sparking) can cause batteries to explode. To prevent
arcing, always place the Speed Control Knob to the "OFF"
position before connecting the cables.
Содержание ENDURA MAX Engine Mount 160
Страница 1: ...ENGINE MOUNT TROLLING MOTOR Owner s Manual...