Minebea MPC-201-25, Инструкция по эксплуатации

Страница: 60 / 124

42
9-1-2.
Sensor Channels
*To edit values or names, double-click the corresponding item name.
Press the [ENTER] or [TAB] key after editing to enter the changes made.
1) Operation buttons
Operation
button name
Description
Copy CH1 to all
CH Pressing this button refreshes all of the channels to reflect the setting
details for CH1.
Note that the CH names remain unchanged.
Setting Description
Enable
Check only those channels to be used.
Waveform data will be acquired and plotted only for the channels
enabled.
Rated capacity Sets the rated capacity for the sensor used.
Can be selected from 196.1 N (20K), 490.3 N (50K),
980.7 N (100K), 1.961 kN (200K), 4.903 kN (500K),
9.807 kN (1T), 29.42 kN (3T). Double-click to enter a
numerical value directly as desired. The units will be
"N" for displayed values and numerical input values,
and "kN" cannot be entered.
* Selections 200K, 500K, 1T, 3T, and numerical input
values exceeding 2000.0 N are possible with ROM
Ver.1.200 or later.
Rated output Sets the rated output for the sensor used.*
Shape Sets the pressure transmitting pin shape to [Round], [Rectangle], or
[Other].
Diameter Enter the dimensions if the pressure transmitting pin shape is set to
[Round].
Width Enter the dimensions if the pressure transmitting pin shape is set to
[Rectangle].
Height Enter the dimensions if the pressure transmitting pin shape is set to
[Rectangle].
Area Enter the cross-sectional area if the pressure transmitting pin shape is
set to [Other].
Name Sets the channel name used on the [Measurement data display] and
[Display channel selection screen] for the Measurement screen;
[Information screen] and [Statistics screen] for the Data processing
screen; and data output displays.