Minebea MPC-201-25, Инструкция по эксплуатации

Страница: 37 / 124

19
6. Starting to Use the Software
The following flow chart describes basic operating procedures.
*1: I a button cannot be clicked, first click [Stop loading data].
*2: Wveform data cannot be acquired if [Stop loading data] is clicked. Buttons should ideally be
clicked while the molding machine is stopped.
*3: If [Restart loading data] is displayed, always click it before starting measurement.
(9) Click [Close] button to close Data
Processing screen.
(7) Click [Data Processing] to display
Data Processing screen
→
Step (8)
Measure molding pressure.
(2) Click [Change conditions],
*1,*2
and set measurement and alarm related
conditions
(3) Start measurement
*3
(4) End measurement
To continue and start next measurement
→
Step (3)
To check measurement results for
waveform data measured → Step (5)
To quit software
→
Step (10)
(5) Click [Statistics] to display
Statistics Screen
(6) Analyze acquired waveform data
→
Step (7)
(8) Load and analyze desired
waveform data.
To measure molding pressure
→
Step (2)
To quit software
→
Step (10)
(1) Launch software
Analyze acquired waveform data.
(10) Click [Quit] to quit software.