Minebea MPC-201-25, Инструкция по эксплуатации

Страница: 27 / 124

9
5-2-3.
Analog Voltage Output Connection
If using analog voltage output, connect as follows using the V-OUT D-sub connector.
* Compatible plug provided: Main unit: DB-25PF-N, cover: DB-C8-J10-F4-1R (JAE)
* Engagement locking screws are inch screws.
Use shield cable for the V-OUT cable, and connect the shield wire to the F.G. terminal.
5-2-4.
USB Connection
Insert the mini-B USB cable provided into the USB connector on the amplifier, and connect it to a PC.
Attach the ferrite core provided around the cable at the MPC-201-25 end as shown below to minimize
the effects of noise on the USB cable.
If this equipment is to comply with CE mark applicable standards, the ferrite core must be attached as
described above.
Pin No. Signal Pin No. Signal
1 N.C.
2 N.C. 14 N.C.
3 N.C. 15 N.C.
4 N.C. 16 N.C.
5 N.C. 17 N.C.
6 +OUT8 18 -OUT8
7 +OUT7 19 -OUT7
8 +OUT6 20 -OUT6
9 +OUT5 21 -OUT5
10 +OUT4 22 -OUT4
11 +OUT3 23 -OUT3
12 +OUT2 24 -OUT2
13 +OUT1 25 -OUT1
(1) Unclip stopper and open.
(2) Wind twice and close.
Approx. 100 mm
25
14
1
13