Mindray SynoVent E5, Руководство оператора

Страница: 18 / 196

1-4
WARNING

When the ventilator input system fails or has faults, please contact us immediately
for specified personnel to service the ventilator.
 Use the humidifiers with a CE mark or recommended by us only.

The ventilator cannot use He and O2 mixed gas.

Do not move the ventilator before removing the support arm from it, in order to
avoid the ventilator getting tilted during the movement.

Nebulization or humidification can increase the resistance of breathing system
filters and that you need to monitor the filter frequently for increased resistance
and blockage.

The ventilation accuracy can be affected by the gas added by use of a nebulizer.
 The ventilator shall not be used with nitric oxide.

The ventilator shall not be used with helium or mixtures with Helium.
 For non-invasive ventilation, the exhaled volume of the patient can differ from the
measured exhaled volume due to leaks around the mask.

Check if the alarm limit settings are appropriate before taking measurement.
 The mains plug is used to isolate the ventilator circuits electrically from the
SUPPLY MAINS
， not to position the ventilator so that it is difficult to operate the
plug.
 No modification of this equipment is allowed.

Do not touch the patient when connecting the peripheral equipment via the I/O
signal ports or replacing the oxygen cell to prevent patient leakage current from
exceeding the requirements specified by the standard.

RJ45 port is used for software upgrades by the personnel trained and authorized
by us only. Do not connect it to other devices or internet.
1.1.3 Cautions
CAUTION

The ventilator must be inspected and serviced regularly by trained service
personnel.
 To ensure patient safety, always prepare pulmotor for use.

Always have a special person attend and monitor the operation of the equipment
once the ventilator is connected to the patient.

During the operation of the ventilator, do not disassemble the expiration valve and
expiratory flow sensor, which, however, can be disassembled in standby mode.