m
Safety Warnings
•
This symbol
m
denotes an important safety tip or warning. Please
read these sections carefully prior to performing any of the instructions
contained in that section.
•
Have a qualified electrical maintenance technician install, adjust and
service this equipment. Follow the National Electrical Code and all
other applicable electrical and safety codes, including the provisions of
the Occupational Safety and Health Act (OSHA), when installing
equipment.
•
Reduce the chance of an electrical fire, shock, or explosion by proper
grounding, over-current protection, thermal protection, and enclosure.
Follow sound maintenance procedures.
•
It is possible for a drive to run at full speed as a result of a
component failure. Please ensure that a master switch has been placed
in the AC line to stop the drive in an emergency.
•
This drive is isolated from earth ground. Circuit potentials are at
115 VAC or 230 VAC above earth ground. Avoid direct contact with
the printed circuit board or with circuit elements to prevent the risk of
serious injury or fatality. Use a non-metallic screwdriver for adjusting
the calibration trimpots.
250-0234 rev 1.qxd 3/12/99 11:14 AM Page i
Содержание RG501A
