22
Calibration
1. Press
JOG
.
2. Press and hold the
FWD
pushbutton. The motor jogs in
the forward direction.
3. Adjust the FWD JOG trimpot until the motor rotates at the desired
forward jog speed.
4. Release
FWD
to stop the motor.
REV JOG
The REV JOG trimpot setting determines the motor speed when it rotates
in the reverse direction in the jog mode. To calibrate REV JOG:
1. Press
JOG
.
2. Press and hold the
REV
pushbutton. The motor jogs in
the reverse direction.
3. Adjust the REV JOG trimpot until the motor rotates at the desired
reverse jog speed.
4. Release
REV
to stop the motor.
DWELL TIME
The DWELL TIME trimpot setting determines the length of time the
motor stops before rotating in the opposite direction. DWELL TIME only
works when the drive is set for Mode 2 and Mode 3 (see page 14 for limit
switch operating modes).
There are 10 DWELL TIME settings (0 thru 9). Set the DWELL TIME
to 0 (the factory setting) for 0.1 second delay. Increasing the setting one
increment higher adds 0.1 second to the dwell time. Set the DWELL TIME
trimpot to 9 for approximately 1 second delay.
250-0234 rev 1.qxd 3/12/99 11:14 AM Page 22
Содержание RG501A
