MIMAKI TS500-1800, Руководство по эксплуатации

Страница: 75 / 184

3-7
1
1
3
Convenient use
5
6
Perform setting to reduce stripes between passes
In case that feeding stripes cannot be resolved even though media correction
( P.2-32)
is performed, make
“MAPS” (Mimaki Advanced Pass System) valid. Feeding stripes become less visible by distributing the pass
boundary. (Supported from the firmware ver.1.10)
1
Press the key in LOCAL.
2
Press the key.
3
Press to select [MAPS].
4
Press the key.
5
Press to set ON/OFF.
• Set Value : ON/OFF
6
Press the key.
• When you select OFF, proceed to the Step 9.
7
Press to change print speed.
• Set Value : -50 to +50%
• MAPS effect differs depending on the set value of the printing speed. Use it after checking effect in
advance.
• When you speed up the printing speed, it takes shorter time to print. However, MAPS effect becomes
weak.
• When you slow down the printing speed, it takes longer time to print. However, MAPS effect becomes
strong and feeding stripes become less visible.
• When printing, if you set the printing speed to 0% and more, MAPS becomes invalid. In addition, it
prints at 0% speed. When you use MAPS, set the printing speed to “minus (-)”.
• When you change the speed, nozzle recovery effect cannot work in some cases. Use it
after checking.
For 4-color For more than 6-color
Resolution Pass Scan speed Resolution Pass Scan speed
300 x 300
1 pass Normal speed
300 x 300
2 pass Normal speed
300 x 300 HQ 2 pass Normal speed 300 x 300 HQ 4 pass Normal speed
300 x 450 HQ
3 pass Normal speed
600 x 450
3 pass Normal speed
600 x 600
2 pass Normal speed 6 pass High speed
4 pass High speed
600 x 600
4 pass Normal speed
600 x 900
3 pass Normal speed 8 pass High speed
6 pass High speed
600 x 900
6 pass Normal speed
600 x 1200
4 pass Normal speed 12 pass High speed
8 pass High speed
600 x 1200
8 pass Normal speed
16 pass High speed
FUNCT I ON
SE TUP
[ ENT ]
SE TUP
F EED COMP .
[ ENT ]
SE TUP
MAPS [ ENT ]
MAPS
: OF F
MAPS
: ON
PR I NT SPEED AD J US T
= 0%
PR I NT SPEED AD J US T
= 1 0%