MIMAKI TS500-1800, Руководство по эксплуатации

Страница: 19 / 184

Names of Parts and Functions
1-7
1
Be
fore Use
3
4
5
6
Heater
Print heater and Post-heater

are equipped on the platen.
Media sensor
The media sensor detects the presence of the media and the
media length.
This machine has two media sensors on the platen (in the rear).
Print-heater Improves the image quality in printing.
Post-heater

Dries ink after printing.
When you control cockling, turn OFF the Post-heater
 ) and use the Post-heater  ) only,
or, set the temperature of the Post-heater

) lower than that of the Post-heater

).
If you put the priority on drying ink, turn ON both heaters and use.
Post-heater

• While the heater is on, the platen is very hot.When the front cover is to be opened or media is to be
replaced, lower the heater temperatures and wait until the platen temperature drops;otherwise, you
can get burned.
• When the media is to be replaced with a thin one, lower the heater temperatures and wait until the
platen temperature drops adequately.Setting a thin sheet of media while the platen is hot may cause
the media to stick to the platen or cause wrinkling or curling of the media.
• Do not heat the media for a long time with the heater in the status not performing printing. The media
surface may float as wave, and it may be the cause of the head rubbing the media.
If the media floats as wave, press the
button on the operation panel to feed the media, or,
perform test feeding ( P.2-28).
• When setting a medium, be sure to cover either of the
medium sensors located on the rear of the platen.
The media cannot be detected unless it is placed over
the sensor.
Post-heater  Print heater Post-heater 
Media sensor