MIMAKI TS500-1800, Руководство по эксплуатации

Страница: 53 / 184

2-23
1
2
Basic Operation
s
4
5
6
Setting a Media
(2) As indicated, fix the media on the paper core
with tape so that the printed surface may be
“involuted”.
• Along the paper core, fix the media on several
positions with tape in the order in the figure so
that the media may not wrinkle.
16
Press to loosen the media.
• Loosen the media until it reaches to the floor.
17
With switches of the take-up device, roll up the media about once.
(1) Making the left switch to [MANUAL] and the right

switch to the direction taking up the media,
take up the media.
(2) Just before the media stretched tight, turn the left switch to [AUTO] to stop.
18
Press again to loose the media.
• Loosen the media until it reaches to the floor.
19
At the front, lift the tension- bar down
slowly.
• Unlock the tension-bar, and then lift it down.
20
Press to lift the tension-bar up and to stretch the loosened media.
• Turn the switch to [AUTO]. Tension-bar lifts, taking up the media, and automatically stops at the proper
position.
• Surface waviness or ruck may affect the quality of currently printed image.
When fixing media with tape, align the media along the direction indicated with an arrow
in the figure.
• If you pull the media too much when fixing with tape, the media tension may not be
even. And, it may negatively affect the media feeding.
• Rolling up the media too tight, covers of take-up device opens and an error [Cover
Open] appears. In this case, open the right cover of the take-up device, and loosen the
tension of the media.
• When the tension bar does not move upward even if you press the
switch, stretch the slack media by operating the switch.
(1)
Set the

switch to the take-up direction of the media, and turn the switch to
[MANUAL]. (The tension-bar is lifted.)
• When the media is fed and the tension-bar is not lifted, turn the
↑↓
switch to the
other side.
(2) When the tension bar arm becomes parallel with the floor, turn the switch to [AUTO]
to stop the tension bar.
(3) Turn the

switch to the take-up direction of the media.
• The media between the take-up device and carriage cannot be printed.
Rock
Tension bar