MIMAKI TS500-1800, Руководство по эксплуатации

Страница: 151 / 184

Warning / Error Messages
5-17
1
1
1
1
5
T
roubleshooting
Message Cause Solution
An error occurred in the main PCB
3.3VB power supply.
• Turn off the power to the machine and turn
it on after a while.
If the same error message appears again,
contact your local distributor to call for ser-
vice.
An error occurred in the main PCB
VCORE power supply.
An error occurred in the main PCB 1.5V
power supply.
An error occurred in the main PCB 12V
power supply.
COM driver becomes the high tem-
perature.
New Print Head was recognized.
The main PCB Q6 is disabled (short
mode).
An error is detected on the waveform
printed on.
Abnormality of the flushing control.
Abnormality of the head voltage con-
trol.
Abnormality of the HDC substrate
voltage.
The machine received some data
other than command data.
• Securely connect the interface cable in
position.
• Use an interface cable conforming to the
specifications.
Any parameter outside the range of
acceptable numeric values was
received.
A maintenance command error
occurred.
USB device initialization failure.
• Turn off the main power to the machine and
turn it on after a while.
If the same error message appears again,
contact your local distributor to call for ser-
vice.
E RROR 1 6 e
M a i n P C B V 3 R 3 B
E RROR 1 8 a
M a i n P C B V _ COR E
E RROR 1 8 b
M a i n P C B V 1 R 5 B
E RROR 1 8 c
H a i n P C B V 1 2
E RROR 1 5 f
H E A D D R I V E HO T
E RROR 1 7 1
N EW H E A D CONN E C T
E RROR 1 7 2
M a i n P C B Q 6 C h e c k K
E RROR 1 8 6
H DC OV E R F L OW
E RROR 1 8 6
H DC UN D E R F L OW
E RROR 1 8 7
H DC S L EW R A T E
E RROR 1 8 8
H DC MEMOR Y
E RROR 1 8 e
F L S NO T COMP [ 1 2 _ _ ]
E RROR 1 8 f
O F F S E T S T A R T [ 1 2 _ _ ]
E RROR 1 8 f
O F F S E T E ND [ 1 2 _ _ ]
E RROR 1 9 d
H DC V 3 6
[ x x x x ]
E RROR 2 0 1
COMMA N D
E RROR 2 0 2
P A R AME T E R
E RROR 2 0 3
M e n t C o mm a n d
E RROR 3 0 4
U S B I N I T E R R