Miller OM-286308A, Руководство пользователя

Страница: 27 / 36

OM-286308 Page 21
5-13. Pairing A Wireless Foot Control With A 14-Pin Transceiver
Ref. 803900-B / Ref. 805625-A
! Unexpected weld output can
cause electrical shock. Wireless
Remote Control can turn weld
output on from distant locations.
Disconnect receiver from remote
14 receptacle and remove bat-
tery from remote control before
servicing equipment.
! Turn off welding power source
before pairing a Wireless Hand
Control or Wireless Foot Control
to another 14 − Pin Transceiver.
During the pairing process, weld
output may be present on the
welding power source previous-
ly linked to the Wireless Hand
Control or Wireless Foot Con-
trol.
.
Pairing is only required for devices
purchased separately. the Wireless
Hand Control and 14 − Pin Trans-
ceiver System and wireless foot
control and 14 − Pin Transceiver
System are paired when purchased
as a system/set. A Wireless Foot
Control, Wireless Hand Control, or
14 − Pin Transceiver can only pair to
a single 14 − Pin Transceiver. The
14 − Pin Transceiver can learn a new
Wireless Foot Control or Wireless
Hand Control address.
1 14-Pin Transceiver
2 Pairing Button (on 14-Pin
Transceiver)
3 Wireless Status Light (on 14-Pin
Transceiver)
4 Wireless Foot Control
5 Pairing Button (on Wireless Foot
Control)
6 Wireless Status Light (on Wireless
Foot Control)
To prevent accidental pairing to un-
intended devices, the Wireless Foot
Control must be within one foot of
the 14 − Pin Transceiver for success-
ful pairing to occur.
Press and release the Pairing Button
(on 14 − pin transceiver).
The Wireless Status Light (on 14 − Pin
Transceiver) will indicate solid amber to
signify that the device is in pairing mode.
Press and release the Pairing Button
(on Wireless Foot Control).
The Wireless Status Light (on wireless
foot control) will indicate solid amber to
signify that the device is in pairing mode.
Both pairing buttons must be pressed
within the 10 second pairing mode
window. After 10 seconds the device will
exit pairing mode if no device is found.
If successfully paired, the Wireless Foot
Control status light will indicate flashing
green and the 14-Pin Transceiver will in-
dicate solid green.
If not successfully paired both the Wire-
less Foot Control and 14 − Pin Trans-
ceiver wireless status lights will indicate
solid red.
1
4
5
6
2
3