Miller OM-286308A, Руководство пользователя

Страница: 25 / 36

OM-286308 Page 19
5-11.
Remote Amperage Or Voltage Control For Welding Power Source With Output Contactor
Wireless hand control operation for welding
power sources with output contactor always
on (Stick, TIG and voltage sensing wire feed
welding).
! Unexpected weld output can cause elec-
trical shock. Wireless remote control
can turn weld output on from distant loc-
ations. Disconnect 14-pin transceiver
from remote 14 receptacle and remove
the batteries from wireless foot control
and/or wireless hand control before ser-
vicing equipment.
1
Welding Power Source Output Control
Switch
The shown setting allows the welding power
source output contactor to be remotely activated
or deactivated, and output can be remotely
increased or decreased.
2
Pairing Button
3 Wireless Status Light
4 Contact Output Control Button
5 Contactor Output Status Light
6 Increase Button
7 Decrease Button
8 Menu Button
9 Display Screen
To turn on the welding power source output con-
tactor, press and hold Contactor Output Button
(approximately 1 second) until Contactor Output
Status Light (blue LED) is illuminated.
To turn off the welding power source output con-
tactor, press and release Contactor Output
Button, Contactor Output Status Light will turn
off. To extend battery life, the Display Screen,
Wireless Status Light, and Contactor Output
Status Light turn off after 10 seconds of inactivity
if the contactor is open.
Press the Menu Button to select percentage,
amperage, or voltage. The selected parameter
is shown on the Display Screen.
.
Press the Menu Button to select percent-
age, amperage, or voltage. The selected
parameter is shown on the Display Screen.
1
4
7
6
5
9
8
Ref. 805626-A
3
2
Top
Front