Miller OM-286308A, Руководство пользователя

Страница: 21 / 36

OM-286308 Page 15
5-5. Introduction
A wireless remote-control system consists of a control and
transceiver.
1
Wireless Foot Control
2 Wireless Hand Control
3 14-Pin Transceiver
The Wireless Foot Control, Wireless Hand Control, and
14 − Pin Transceiver are capable of remotely turning on the
output contactor and adjusting the output level of a welding
power source.
The Wireless Hand Control is equipped with a digital display
cable of providing three parameters: percentage of available
output (default), amperage, and voltage. Amperage and
voltage can only be displayed if the welding power source has
amperage and voltage feedback available at the Remote 14
Receptacle, and is only viewable while welding, or when the
feedback is present. The display is for reference only.
• Each Wireless Foot Control and Wireless Hand Control has
a unique address
•
The 14-Pin Transceiver stores the address in a permanent
memory
• The 14-Pin Transceiver can only pair to a single Wireless
Foot Control or Wireless Hand Control.
• A Wireless Foot Control or Wireless Hand Control can only
pair to a single 14-Pin Transceiver.
• The 14-Pin transceiver can learn a new Wireless Foot Con-
trol or Wireless Hand Control address (see sections 5-12 or
5-13 in this manual for programming instructions).
.
Pairing is only required for devices purchased separately.
The Wireless Hand Control, 14-Pin Transceiver System,
and Wireless Foot Control are paired when purchased as
a system/set.
1
2
3
Ref. 805625-A / Ref. 805626-A / Ref. 805627-A
1
2
5-6. Battery Installation
1 AA Batteries
Install four AA Batteries in shown
orientation.
.
Any type of AA battery, including
re-chargeable batteries, may be
used (battery life may vary).
2 Wireless Hand Control
Remove the accessory strap/
magnet.
Lift the bail on the on the
1/4 turn
captive panel fastener.
Rotate the bail of the
1/4 turn
fastener counterclockwise.
Simultaneously lift the fastener and
slide the battery cover down.
3
Wireless Foot Control
Rotate the captive panel fastener
knob counterclockwise.
Simultaneously lift the fastener and
rotate the door down.
1
Ref. 805625-A / Ref. 805626-A
3
Battery Orientation