.
A complete Parts List is available at www.MillerWelds.com
OM-254915 Page 53
7-4. Feeder Drive Assembly Maintenance
805 350-A
Retract wire onto spool.
1
Pressure Roll Assembly
2
Drive Motor Shaft
3
Drive Roll
4
Screw
Use wire brush to clean drive roll.
5
Drive Roll Idler
6
Shoulder Washers
Use wire brush to clean idler.
7
Outlet Guide
8
Wire Inlet Guide
Pull guide toward rear of feeder to
remove. Install new guide.
Thread welding wire and adjust
drive roll pressure, if necessary
(see Section 5-16 or 5-17).
Drive roll and idler are available for
the following wire size ranges:
.035 wire size
.040 wire size
.047 wire size
When changing wire size, change
control box drive roll and idler, gun
pressure roll and drive roll.
Tools Needed:
3
4
2
1
8
7
5/16 in.
5
6
Notes
