M i g h t y M u l e 2 0 0
21
RED to POSITIVE
BLACK to NEGATIVE
Battery Cable
from Control Box
Connecting the Transformer
Connecting the Battery
Step 1
Make sure the power switch is
OFF
before
proceeding to the next step.
Step 2
Select the electrical outlet where you will
plug the transformer. Measure the distance
from this outlet to the control box following
the path where the wire will be laid. After
you have measured how much wire is
needed, cut the wire to the appropriate
length.
Step 3
Lay the measured length of low voltage
wire in a trench following a path from the
selected electrical outlet to the control box.
Wires coming up from the ground should
be run through PVC conduit to protect them
from lawn mower blades, weed eaters, and
grazing animals. Be sure to bury the wire
laid in the trench.
Low Voltage Wire
from Transformer
Wires from Battery
Power Cable from
Opener Arm
POWER
OFF
120
AUTO CLOSE
T ME
MIN
MAX
STALL
FORCE
ON OFF
SG1
ED1
K1
06
AVR-
SP
D1
C2
C7
C15
LED3
D15
R20
IC4
D16
D13
D14
K2
BATT BATT+
STATUS
ANT SHLD
S9
8874
EDGE
COM
LOCK+
LOCK -
PGOK200 Rev. XC
M_BLK
M_RED
VAR2
GRN
VAR3
R3
VAR1
VAR4
VAR5
PF1
VAR6
WHT
GTO Inc. Tallahassee, FL
CYCLE
EXIT
SAFETY
COM
PVC Pipe
Antenna Wire
CHGR
CHGR
IMPORTANT:
Use either transformer
or solar panel. DO NOT connect both
transformer and solar panels to the opener
control board at the same time. It will
damage the control board.
Switch
cessory W
accessory wir
Remove the screw
and lift the cover off
to gain access to the
control board.
ON/OFF Switch
Step 1
IMPORTANT:
Make sure the power switch on the control box is in the
OFF position.
Step 2
Place the 12 Volt automotive or marine type battery and its
weatherproof case within 6 feet of the fence post where the opener arm
is mounted.
Step 3
Attach the battery wires provided, to the terminals of the battery. Take
care to attach the BLACK wire to the NEGATIVE terminal and the RED
wire to the POSITIVE terminal. Reverse connection will cause damage
to the control board.
