Navn CoWelder™
Produkt UR10E-PI350
Version
A – 1.5.2021
Udfærdiget af:
CTM
32
3.3 Program templates
Sub Programs
Arc_On
Turns on the Arc, and wait for the Arc Detect signal to go on, when
Arc is enabled on the Arc On/Off button on the operators pendant.
Arc_Off
Turns off Arc, and wait for the Arc Detect signal to go off.
Select_TIG_Process
Select TIG mode at the welding machine.
Select_AC_TIG_Process Select AC-TIG mode at the welding machine.
Pulse_Off
Turn’s pulsation OFF in the welding machine.
Fast_Pulse_On
Turn’s ON Fast pulsation of the welding current.
Slow_Pulse_On
Turn’s ON Slow pulsation of the welding current.
Slow pulsation is turned OFF with the Pulse_Off Sub Program.
Fast_Pulse_Synergic
Turn’s ON Synergic Fast pulsation of the welding current.
Pulsation frequency is increased with increasing current.
Synergic Fast Pulsation is turned OFF with the Pulse_Off Sub
Program.
Wire_On
Turn’s ON wire feeding. Wire feeding must also be enabled in the
welding machine’s active program.
This is done in the Secondary Parameter menu on the welding
machine, when the Slope UP and Slope Down LED’s are both on.
If the display shows 1.08, the active program in the PI is selecting
program number 8 in wirefeeder 1.
One PI machine can access 4 Coldwirefeeders.
Each Wirefeeder holds 20 programs
Wire_Pulse
Select’s Pulsated wirefeed. If Slow pulsation with Hi and Lo Pulse
time greater than 0,20 sec is set in the welding machine, then the
wire pulsation is syncronized with the welding current pulsation.
Wire_Continous
Set continuous wirefeed disregarding pulsating current.
Wire_Off
Turn’s OFF wire feeding.
Wirefeeding can also be stopped temporaryly, by setting wirespeed
to 0.
But at the end of the welding, Wire_Off must be enabled, otherwise
the wire will be retracted.
