Microplex LOGIJET T4, Руководство оператора, Страница: 86 / 117

86 Panel Functions
________________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID T4 / T5 / T6 / T8 Edition 2.0
6.31. Adjusting the Cutting Position
The cutting position
‚
is identical to the detected gap position, i.e. with
the perforation or the start of the label. With this function a fine setting of
the cutting position is carried out.
The setting range for the offset is ± 2.0 mm.
ON LINE
↵
PROG ESC
FEED
Ù
ON LINE
↵
FEED
Ù
ON LINE
↵
ON LINE
↵
FEED
Ù
ON LINE
↵
ON LINE
↵
Panel display
[ON LINE ]
[OFF LINE ]
[Menu Level 1 ]
Ÿ Ÿ Ÿ
[Engine ]
[Paper Move ]
Ÿ Ÿ Ÿ
[Cutting Menu ]
[Cutting Pos. ]
[Position: + 0.0 mm ]
Ÿ Ÿ Ÿ
[Position: - 0.5 mm ]
[Position: - 0.5 mm ]
Notes
Turn the printer OFF LINE with this
key.
The PROG ESC key gives the user
access to the menu structure.
Press the FEED
s
or CUT
t
key until
[Engine ] is displayed.
Press the FEED
s
or CUT
t
key until
[Cutting Pos. ] is displayed.
The currently set value is displayed.
Press the FEED
s
or CUT
t
key until
the desired offset is displayed.
The cutting position is shifted 0.5 mm
in feed direction.
Turn the printer ON LINE again:
Press the ON LINE
↵
key longer than
2 seconds.
‚
This panel function is valid for printers equipped with a cutter (option).