Microplex LOGIJET T4, Руководство оператора

Страница: 37 / 117

Handling of Consumables 37
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID T4 / T5 / T6 / T8 Edition 2.0
4.6. Printhead Position Adjustment
The printhead 0 line can be variably adjusted from 2mm
(from the left edge of the label) to 13mm:
(does not apply for SOLID T4)
1. For adjustment first loosen the two thumb screws (1).
thumb screws
Fig. 4.6.a Loosening the thumb screws
The printhead may and must not be removed for these
operations.
2. Shift the printhead to the required position.
3. Tighten the screws again.
The following operations have to be done to suit the “lateral
position“ of the ribbon to the new position of the printhead.
4. Loosen the black plastic discs (4) on the ribbon roll up
mandrel and the ribbon unwind mandrel at the back using a
2mm Allan key.