Micromeritics ASAP 2460, Руководство оператора

Страница: 260 / 468

Preventive Maintenance ASAP 2460 Operator’s Manual
7-18 246-42800-01 - Aug 2013
8. Close valves 8 and 18, and record the pressure as the
Initial Reading
for Inlet Ports in the table
below.
9. Wait 3 minutes, then record the pressure as the
3 Minute Reading
in the table above.
10. Subtract the first reading from the second reading and record in the
Difference
column in the
table above.
11. If the value in the
Difference
column is at or below the value in the
Limits
column, enter Yes in
the
OK?
column. If the Difference value is not below the Limits value, a gas inlet valve, inlet
plug, or gas line is leaking from atmosphere.
12. Close all gas inlet manifold valves (21 through 26).
13. Record the pressure as the
Initial Reading
, then begin timing as soon as you complete the next
step.
14. Gas inlet valves 21 through 26 must remain closed during this procedure. Pressurize the inlet to
valve 21 by opening the supply valve or removing the port plug. This allows gas or air to
pressurize the inlet valve above the seat.
15. After 3 minutes, record the pressure as the
3 Minute Reading
. Subtract the first reading from the
second and record in the
Difference
column in the table above.
16. Repeat steps 13 through 15 for the inlet valves 22 through 26.
Test Initial Reading 3 Min. Reading Difference Limits OK?
Inlet Ports
30 microns
(0.3 mmHg)
Valve 21
2.1 microns
(0.0021 mmHg)
Valve 22
2.1 microns
(0.0021 mmHg))
Valve 23
2.1 microns
(0.0021 mmHg)
Valve 24
2.1 microns
(0.0021 mmHg)
Valve 25
2.1 microns
(0.0021 mmHg)
Valve 26
2.1 microns
(0.0021 mmHg)