Smart Swing 3
®
Installation Manual
SMART SWING 3 ®
Page 7 of 36
6
Fixing plate SMART SWING 3
7
Control Unit SMART SWING 3
8
SMART SWING 3 Housing
9
Motor
10
Motor gear box mount bracket
11
Gear Box
12
Spindle
13
Fixed Stop
14
Bush
15
Retainer
16
Motor gear box end support bracket
17
Securing bolt
18
Fixing bolt
19
End cover plate Right
20
End cover bracket Right
4.0 Pre-Installation Information
4.1 Safety Precautions
•
Only MICOM trained technicians are authorized to carry out these operations.
•
Ensure all power is OFF to the unit, before performing any work or maintenance.
•
Do not climb or put weight on any door or header parts.
•
Do not let children play with the operator or the electrical board.
•
Keep remote controls away from children.
To avoid bodily injury, material damage and malfunction of the product, the instructions contained in this manual
must be strictly observed during installation, adjustment, repair and service.
Training is needed to carry out these tasks safely.
4.2 Compliance Codes and Standards
It is the responsibility of the final installer and/or installation company, to certify that the final completed operator is
installed in accordance with local building codes and applicable laws.
Be sure to complete the site acceptance test before taking the door into operation.
Caution
•
All wiring must conform to standard wiring practice in accordance with national and local wiring codes.
•
Door must swing freely through the entire opening and closing cycle before beginning of installation.
•
Incorrectly installed or improperly adjusted door operators can cause property damage or personal injury.
•
All dimensions are given in inches (millimeters), unless otherwise note.
•
Before installation, verify door frame is properly reinforced and is well anchored in the wall.
•
Concealed electrical conduit and concealed switch or sensor wires should be pulled to the frame before
proceeding.
