Smart Swing 3
®
Installation Manual
SMART SWING 3 ®
Page 16 of 36
Step 4.
Set 3-position switch to
manual (0) and allow door to close
under spring pressure.
Test and adjust arm at full closed
position as necessary so door
closes fully with frame.
Step 5.
Press Test/Learn button to begin the learning cycle. See Learning Door Cycle.
5.6.2 PULL / SLIDE Arm
Notes: Operator to be mounted so that base of drive shaft is clear above the door top. See Installation Drawings.
A solid spacer material or filler may be required to compensate for any gap between the back of base rail and wall.
Ensure, before fixing base rail to the doorframe, that access holes for power supply cables are in line, if required
Step 1.
Without PULL arm fitted, set 3-position switch to Hold Open (II). The drive shaft with turn fully until hitting the in-built
fixed doorstop, so charging the spring.
Step 2.
Manually open the
door to full open (Approx.
100deg open position).
Fit PULL arm to the drive shaft
at the full open position so the
roller touches the door.
Mark the open position where
roller touches the door.
