Smart Swing 3
®
Installation Manual
SMART SWING 3 ®
Page 20 of 36
-
This setting is the duration of the door open cycle in seconds.
-
Timer starts when the door reaches the backcheck area.
-
Use the “UP” and “DOWN” buttons to select the desired opening time.
7.1.8 Hold on manual open (No, 1-5)
-
This setting is the length of time the door must be physically held opened, when the door is manually pushed open by a
pedestrian.
-
The door must be opened at least 60% of the door swing, for this feature to activate.
-
Use the “UP” and “DOWN” buttons to disable or enable this feature and set the timer value.
7.1.9 Electronic Door stop (YES/NO)
-
This setting is to enable or disable the electronic door stop.
-
This feature, when selected, will prevent the door moving during heavy wind conditions when the door reaches the full
opened position.
7.1.10 Electric lock (NO/YES)
-
This setting is to enable or disable the electronic lock delay/output
-
Use the “UP” and “DOWN” buttons to enable or disable the electronic lock delay/output
7.1.11 Electric lock delay (0.2-2.0)
-
This setting is the time is seconds for the delay between activating the electric lock and the start of the opening cycle.
-
Use the “UP” and “DOWN” buttons to set the proper electric lock/opening delay.
7.1.12 Latch position (10-30)
-
This setting will adjust the door latch position during the closing cycle
-
Use the “UP” and “DOWN” buttons to set the point for the latch position.
-
Activate the door. During the closing cycle, check the position where the latch begins.
-
Check this setting is correctly adjusted.
7.1.13 Backcheck position (70-98)
-
This setting is to adjust the door backcheck position of the opening cycle.
-
Use the “UP” and “DOWN” buttons to set the point for the backcheck position.
-
Activate the door. During the opening cycle, check the position where the backcheck begins.
-
Check this setting is correctly adjusted.
7.1.14 Push & Go (NO/YES)
-
This setting is to disable/enable the Push & Go feature, also known as Manual Activation, when the door is manually
pushed by hand.
-
Use the “UP” and “DOWN” buttons to disable or enable this feature
7.1.15 Push & Go active time (1-30)
-
This setting is to adjust the duration of the door open cycle in seconds. From when the door is manually opened, to when
the Push & Go feature is enabled.
-
Use the “UP” and “DOWN” buttons to select the desired opening time.
7.1.16 Power Close (NO/YES)
-
This setting can disable/enable the power close assist feature.
