MHP JNR4, Руководство пользователя

Страница: 8 / 40

Step 1: Deck/Patio Base Mounting Assembly
(Fig. 5)
1. Turn base on edge and insert the 2’ post. Align the notches in
the post with the notches in the base. IMPORTANT: Close
tolerances may require you to tap the top of the post to seat it
completely in the base socket which will then align the bolt
slots.
2. Fasten post to base with four ¼ - 20 x ¾" Hex bolts, washers
and Kep nuts. Follow exact placement of washers as indicat-
ed. Tighten securely.
3. Attach the tube clip with the 8 - 32 self-tapping screw either on
the right or left side of the base depending on the direction of
your gas supply line.
Step 2: Deck/Patio Mounting Installation
(Fig. 6)
Position the patio base at the desired location on a deck or
patio. CAUTION: Be certain there are no combustible mate-
rials above, behind, left or right closer than 18" away.
1. Mark the location of the four holes at the outside corners of the
patio base and drill four holes. The base will be fastened down
with lag bolts (not supplied by MHP) after you have connected
the gas supply line. The top post notch is the front and the rear
access door will be in the back of the grill.
2. Run the gas supply line into the post from the bottom to reach
the access door and bend it 90° to exit the base at either notch.
The patio base is notched on two sides to allow the gas line to
exit either right or left.
3. Secure the gas line with the tube clip. (Option: On a raised deck
if the gas supply line is to be run straight up into the post from
below use the tube clip to attach the gas line to the deck for
support.
4. At the access door connect a 3/8" flare coupling (not supplied by
MHP) to the gas supply line and Stainless Steel tubing. Position
the tubing in the top notch of the post. Bend the tubing at the top
end to match the Feed Line of the grill valve. Do not kink the
tubing.
TUBE BENDING : For proper bending of the stainless steel tubing, see
page 26 for bending instructions.
Step 3: Attaching The Grill Head Bottom To The Deck/
Patio Post
(Fig. 7 & Fig. 8)
1. To make the post-to-flange connection easier, remove the grill
burner by taking out the small clip located under the bottom grill
head. This will allow access to hold the Kep nuts inside the
post.
2. Set the grill head bottom carefully in place, align holes and use
the ¼ - 20 x ¾" bolts and ¼-20 Kep nuts to attach the grill
flange to the post.
Please check to be sure that all parts are included before proceeding.
Contact your dealer if any parts are missing.
Parts Quantity
2' Post 1
Patio Base 1
Post Access Door 1
Grease Cup Holder 1
28” Stainless Steel Tubing 1
Stainless Steel Grease Cup 1
Hardware Kit
¼ - 20 x ¾" Hex Head Bolts 7
¼ - 20 Kep Nuts 7
¼" Flat Washers 7
8 - 32 x ½" Self Tapping Screw 1
Tube Clip 1
8
Mountings
Deck/Patio Base
•
Deck/Patio base fits all MHP Grill Heads
•
The gas supply may be either LP or Natural.
•
The grill head should not be attached to the post until the base
has been mounted to the deck or patio.