MHP JNR4, Руководство пользователя

Страница: 15 / 40

JNR & WNK Assembly Instructions
Grill Head Assembly
Instructions

The grill head bottom must be attached to the
mounting before starting.

It is easiest to work with the grill in the upright
position.

The difference between the JNR and the WNK is
the WNK is larger, has two side shelves and the
warming rack fastens differently.

Leak test all gas connections before using.

Caution: Combustible material should never be
within 18 inches of the bottom, back or sides of
your MHP Gas Barbecue Grill.
View of JNR & WNK Grill Head Components
Step 1: Control Panel & Heat Shield
A.
Attaching the Heat Shield and Control Panel Assembly
(Fig. 19)
1. Attach the complete control panel assembly to the front of the
grill head with 1/4—20 Kep nuts.
2. Leave the (2) nuts holding the heat shield on, to serve as spac-
er nuts.
3. Make sure the valve orifices on the control panel aligns with the
burner venturi correctly and that the venturi tubes go over the
valve orifices at least 1/4" to 1/2" (see fig. 22 on page 16).
B. Connecting the Control Panel Support Brackets
(Fig. 20)
1. Two support brackets are connected beneath the control panel
to the grill head for added support. Push a ¼ - 20 x 1¼" Phillips
head bolt through the grill head from the inside.
2. Slip the support bracket in position, fasten with a ¼ - 20 Kep
nut.
3. Attach the control panel to the support bracket by pushing up a
¼ - 20 x ½" Phillips head bolt through the support bracket and
through the lower lip of the control panel, fasten with a ¼ - 20
Kep nut.
15
Back View of Control Panel
Fig. 19A
Note: Hose and Gaslow Regulator is preassembled to the valve
at the factory. (Fig. 19A)