MHP JNR4, Руководство пользователя

Страница: 16 / 40

JNR & WNK Assembly Instructions
C. Ignitor Wire Connection
(Fig. 21a)
1. Tip the grill on its back (or upside down) and attach the
control panel ignitor wire to the terminal sticking out from
the bottom of the grill.
Be careful not to crack the deli-
cate porcelain insulator
D. Battery Installation
2. Remove the collare around the igniter button by turning it
counter-clockwise. Place AAA battery “+” side down. Fig.
21b.
E. Orifice Engagement
(Fig. 22)
At the top end of each valve there is a tiny gas opening known
as the orifice. Gas exits the orifice and enters a venturi where
it mixes with air coming in from the side air shutter. The proper
mixture of air and gas produces a clean blue flame at the burn-
er.
Make sure the valve orifice on the control panel aligns with the
burner venturi tube correctly. The orifice should fit into the ven-
turi tube
¼ " to ½" inches as shown below.
WARNING! Always check the alignment of the orifice and the
venturi whenever the grill has been moved. Make sure that the
orifice fits into the venturi tube 1/4" to 1/2". Failure to make
this connection may cause fire and result in serious body
injury or damage to your grill.
Step 2: Connect the gas supply line
(Fig. 23)
A. For LP-Gas Tank and LP Cart Models:
1. Pass the Gaslow Regulator Hose through the hose clamp
ring and screw the ring to the front of the left leg.
2. Connect the regulator end of the hose to the LP-Gas Tank.
Tighten securely and leak test both connections. See
Leak Testing on page 23.
B. For Natural Gas Carts Using 12 foot Hose:
Connect one end of the supplied 12 foot hose to the grill valve
connection behind the control panel. Then, connect the quick
disconnect valve on the hose to the gas supply line connection.
Tighten securely and leak test both connections. See Leak
Testing on page 23.
Do not allow
the gas hose
to come in
contact with
the bottom
of the grill
head.
C. For Deck/Patio & In-Ground Mounts Using 30" Flexible
tubing.
(Fig. 24)
Connect the 30" flexible tube to the incoming gas supply using
a 3/8" flare coupling (not supplied). Attach the other end to the
grill valve connection behind the control panel. To tighten se-
curely use two wrenches. Hold valve joint with one wrench and
tighten the hose fitting with second wrench. After Tighten leak
test both connections. See Leak Testing on page 23.
Do not use compound or
Teflon tape on flare fittings.
Ignitor
1.Connect Ignitor
Wire to Bottom
of Grill Head
Fig. 21a
16
Fig. 21b
Push
Button
Spring
AAA Battery
+
Electronic
Ignitor