MHP JNR4, Руководство пользователя

Страница: 13 / 40

Mountings
Step 2: Built-In Mounting Assembly
IMPORTANT: Since the mounting is attached directly to the grill,
you must first partially assemble your grill by attaching the control
panel to the grill head (refer to the appropriate grill section for
assembly instructions).
Then the built-in mounting heat shield must be attached to the
bottom of the grill head using four ¼-20 x ¾" bolts, see
fig. 14
“Complete View” illustration.
Do not forget to remove the protective film from all stainless steel
parts of your built-in mount.
To assemble the built-in frame
(Fig. 17)
1. Align the holes of the right hand “L” bracket with the face
panel (the face panel’s 12 vent slots should be on the top)
and insert two ¼ - 20 x ¾" Hex bolts and fasten with flat
washer, lock washer and nut, do not tighten at this time.
When properly connected the grill support tabs on the “L”
bracket should be facing up and inward.
2. Repeat procedure to connect the left hand “L” bracket.
3. Attach the rear bracket to both the right and left “L” brackets
using two ¼ - 20 x ¾" Hex bolts at each end. Secure bolts
with a flat washer, lock washer and nut.
4. Attach the frame to the bottom grill head by aligning the frame
support tabs with the grill head bottom holes. Insert the ¼ -
20 x 1 ¼" Hex bolt from inside the grill head and screw it into
the threaded frame support tab.
To connect the full assembly to the enclosure.
5. Slide the grill head into the opening 3/4 of the way in. Con-
nect the gas supply using an approved outdoor connector.
Check for gas leaks. (See Gas Leaks page 23.)
Note: Be certain that the gas pressure is between 6.5" and
7.5" water column. Excess gas pressure can cause warping
and damage to grill head.
6. When finished connecting gas supply, slide grill all the way
into to opening so that the “L” bracket face flanges fit snuggly to
your enclosure face. Drill a hole in the masonry to match up with
the “L” bracket face flange holes and fasten with lag bolts (not
supplied).
Do not build a shelf below the bottom of the grill. The grill
requires an open area for proper ventilation and service ac-
cess.
7. Install the pre-assembled door kit by securing with a suitable
fastening method. (Anchors and/or screws not included.)
When you complete the mount assembly go
to the appropriate Grill Assembly Section
and finish assembling the grill head.
13