MHP JNR4, Руководство пользователя

Страница: 21 / 40

1. With a slotted screwdriver or 1/4" wrench,
remove the rear mounting screw on the back
of the burner venturi where it meets the grill
head bottom. Use a 11/32" or adjustable
wrench on the nut on the outside of the grill
head bottom (Fig. 1).
CAUTION: DO NOT BREAK
CERAMIC ELECTRODE WHEN
REMOVING OR REINSTALLING
BURNERS!
SUPPLEMENTARY ASSEMBLY INSTRUCTIONS FOR COLUMN, PATIO BASE AND IN-GROUND POST
Prior to assembling your WRG4 or TRG2 grill with the Optimum Console, Patio Base or In-Ground Post, the following
instructions must be followed to gain access to the mounting holes in the grill head bottom. Assembly of grills with the
WCP or WCN base begins on page 6 of the Owner’s Manual
.
8-32 x 1/2"
Hex Head Slotted
Nut On
Outside
Of Casting
3/16" To Surface
Ceramic
Electrode
Fig. 1
2. Under the control panel, remove the screw
on the burner where it meets the orifice. Use
a 1/4" wrench or a slotted screwdriver for
this.
(Fig. 2).
8-32 X 1/2"
Hex Head Slotted
Fig. 2
21
3. Once these screws are removed from the burner, care-
fully lift each out of the grill. For the Column, the right and
left infrared burners need to be removed. For the MPB
Patio Base and the MPP In-Ground Post, only the center
infrared burner needs to be removed.
4. Be careful not to damage the igniter when removing the
burner.
5. For mounting the grill head on the Column, follow the
instructions on page 10 and 11 of the MHP Owner’s Manu-
al.
6. For mounting the grill head on the MPB Deck/Patio
Base, follow the instructions on page 8 of the MHP Own-
er’s Manual.
7. For mounting the grill head on the MPP In-Ground Post,
follow the instructions on page 9 of the MHP Owner’s Man-
ual.
8. After the grill head is mounted, reinstall the burners into
the grill head bottom. Insert the venturi tube through the
opening at the front of the grill head, and over the orifice
holder. Make sure the burner venturi is fully engaged over
the orifice holder, then tighten the venturi set screw se-
curely.
WRG4 and TRG2 Assembly Instructions