MHP JNR4, Руководство пользователя

Страница: 7 / 40

Mountings
Continue Assembly Instructions
1. The LP Tank Holder Ring Connects to the lower
shelf cross frame with the ring notches resting on
the axle frame.
2. Align the rear tank ring-fitting hole over the lower
cross frame hole. Insert a 1/4-20x5/8" slotted bolt
through the top and fasten with a 1/4-20 Kep nut
from below.
3. Fasten the thumb screw (1/4-20x3/4") to the tank
ring fitting with the 1/4-20 Hex nuts. The Hex nut
slips into the captive slot on the tank ring fitting.
4. Use a 1/4-20x1-1/2" slotted bolt and a 1/4-20 Kep
nut to connect the tank holder flanges together.
Step 3: Tank Holder Ring Assembly For LP
Gas Models (
Fig. 5)
If the grill is to use Natural Gas from the supplied 12-
foot hose (Fig. 6): the hose must pass through the hose ring
( See Fig. 1 ). The hose will have a quick-disconnect
fitting at the source and the source will have a gas shut off
valve with easy access
.
For Natural Gas Models
(Note: Tank Holder Ring is not Included With Natural Gas
Models).
Step 3: WCP3/WCN3 Lower Shelf Assembly (Fig.
Fig. 3
Step 3: JCP3/JCN3 Lower Shelf Assembly (Fig. 4)
Fig. 4
Fig. 5
Fig. 6
Natural Gas Models
When you have completed the mounting assembly go to
the appropriate Grill Assembly Section and
Assemble the grill head.
Deck/Patio Mounting
Assembly Instructions (MPB)
• All grill head models may be mounted on the Deck/Patio base.
• The gas supply may be either LP or Natural.
•
The grill head bottom should not be attached to the post until
the mount is fastened to a deck/patio .
Continue on Following page 7