MHP JNR4, Руководство пользователя

Страница: 12 / 40

Mountings
Built-in Mounting
Assembly Instructions
(NMS-GS, NMS2-GS
Enclosure Sleeve and NMS-DS Door Set)

The WNK or TJK model grills may be mounted as a built
-in with the NMS-GS enclosure sleeve.

The WRG4, WHRG4, TRG2 and THRG2 requires the
NMS2-GS enclosure sleeve.

For use with natural or hard – plumbed propane gas.

Do not place or store a spare LP gas cylinder under or
near the grill.

Enclosure must be constructed from non combustible
materials and with adequate ventilation.

The Built-In kit and grill head connection will be assem-
bled upside down.

Refer to appropriate section for grill head assembly.
Please check to be sure that all parts are included before proceed-
ing. Contact your dealer if any parts are missing.
Parts Quantity
GRILL HEAD ENCLOSURE SLEEVE
Front Face Plate for NMS (
26" W x 11" H x 1½" D)
1
Right Side “L” Bracket 19" x 11" 1
Left Side “L” Bracket 19" x 11" 1
Rear Support Bracket 26
1/8
" long 1
Grease Tray 1
Heat Shield 1
Hardware Kit
¼ - 20 x ¾" Hex Head Bolts 12
20 x 1 ¼" Hex Head Bolts 4
¼" Nuts 4
¼" Flat Washers 4
¼" Lock Washers 16
NMS-DS DOOR SET
Frame for Door Set 1
Left Hand Door 1
Right Hand Door 1
Magnetic Catches 2
Door Handles 2
Important Notes:
Your structure should have a 3" to 4" concrete base on a sand
footing.
The panel doors must have a 4" to 6" minimum elevation from the
ground.
If your structure includes a back splash, allow 11" to the back edge
of grill opening to allow the lid to open completely.
Combustible material should never be within 18 inches of the
bottom, back or sides of your Grill
.
Complete View Of Built-In
Step 1: Required Dimensions For Built-In
(Fig. 16)
1. The grill head fits into an opening of 27½" wide by 11" high
by 18" deep.
2. The Panel doors fit into an opening of 27¼" wide by 16¾" tall.
3. The side burner fits a surface opening of 10¼" wide by 11¾"
front to back. It should be at least 5" away from the grill open-
ing.
(The front face flanges on the mounting and the panel doors
overlap the required opening surfaces by 1
5/8
" and provide a
clean look.)
12
The NMS and NMS2 Kits have not been submitted to CSA for approval as of this printing.