Mhouse GDX01, Инструкция по установке и эксплуатации

Страница: 12 / 214

13 . Fix one end of the manual release cord to the carriage and the other
end to the knob (
fig. 23 ). Note – Ensure that the manual release
knob is positioned at a maximum height of 180 cm from the ground.
14 . • If the door is SECTIONAL: establish the length of distance B con-
sidering the constraints of values A and E ( fig. 24-a ).
• If the door is UP-AND-OVER: establish the length of distance B
considering the constraints of value F ( fig. 24-b ).
Note – If values A, E or F allow, the automation can also be fixed
directly onto the ceiling (minimum 4 mm).
15 . Fold the two ceiling mounting brackets to an “L” and mount in the
vicinity of the gearmotor, by means of screws and nuts (
fig. 25 ).
Note – choose the most suitable hole on the brackets to observe
distance B selected in point 14 .
IMPORTANT ! – Perform the operations below the door CLOSED .
5.2 – INSTALLING THE BUFFER
BATTERIES mod. ME
The buffer batteries are self-charging with a voltage of 12V and power of
0,8 Ah. These are particularly useful in the event of a sudden power failure.
The gearmotor enables installation of 2 batteries.
In general, when charged, the batteries guarantee an autonomy of
approx. 6 - 7 consecutive movement cycles (1 cycle =
opening - closing )
This value can vary according to the type and weight of door.
To install the buffer batteries, proceed as follows:
01 . Remove the screw of the control unit protection cover and remove
the cover (
fig. 26 ).
02 . Use a screwdriver to open the two cable routing slots ( fig. 27 ).
03 . Insert the battery cables in the cable routing slots ( fig. 28 ) and posi-
tion each battery in the relative seat ( fig. 29 ).
IMPORTANT – The batteries must be installed before mounting
the automation on the ceiling and wall.
23
26
27
28
24-a
24-b
25
A
D
E
B
F
B
V6 x 14
M6
B (4 ÷ 400 mm)
from 65 to 100 mm
English
12 – English